Welcome to the Lingcheng Electronics website!
Hotline: +86-13014650631 +86-0371-67982058
Welcome to the Lingcheng Electronics website!
Hotline: +86-13014650631 +86-0371-67982058

Arrangement of quenching and quenching process of threaded rod
2019-06-09

If you want to know about our products, please call our company at any time.

Call me:+86-13014650631

+86-13014650631
    How is the tooth bar screw quenching and tempering process suitable? How is the tooth bar screw quenching and tempering process called complete? Today, I will analyze this question for everyone, because a few users have called our technical consultant manager a few days ago. They are also asking this question. Today, we will focus on it to analyze the process of our users. You have a general understanding, then, then look at the manufacturer and then decide whether you want to invest in this project! 
    The studs quenching and quenching and tempering are said to be two parts, one is the studs quenching and the other is the studs quenching and tempering (note that the studs and the lead rods are actually a kind of workpiece, It's just the difference between the north and the south, the name is not the same, huh, huh, you know, there is not much explanation here.) Both are heating processes, but the temperatures required for these two processes are different, quenching requirements The temperature is 800-900 degrees, and the temperature required for quenching and tempering is about 400 degrees. Of course, the quenching and quenching and tempering temperatures required by different materials will be different, but the difference will not be too big. For details, please consult us. Technical consultant manager. 
    The process of quenching and quenching the threaded rod is as follows: 1. The workpiece is transferred to the induction heating coil for quenching. At this time, the transmission speed is required to be fast, and then the water is sprayed and cooled rapidly. This process is called quenching; Continue to transfer, send to our second heating equipment, and carry out the second heating. This time, the transmission speed is not required to be too fast. Slowly enter the induction heating coil and slowly come out. The heating temperature can reach more than 400 degrees. The quenching temperature requirement is low, this is the approximate process of the tooth bar, that is, the screw quenching and quenching.
Zhengzhou Lingcheng Electronic Technology Co., Ltd. @ Copyrights Sitemap